Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Winchester Super X brass
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="lilboots" data-source="post: 2191655" data-attributes="member: 24733"><p>Sorry if this has been discussed and i missed it. I have just started reloading, and was reloading some .308 Winchester brass I had bought and shot. Everything was fine until I went to seat the bullet. When i did, the brass buckled at the shoulder, and not just barely. So, figured I had my die set wrong, so backed it off, and tried another. Didnt even start to seat the bullet. Slowly started tightening the die back down until it seated the bullet, and buckled again. After the 4th piece of ruined brass, i gave up.</p><p></p><p>Cousin, who is much more experienced at reloading, comes over, goes through the setup process again to make sure its right, and buckles the brass. So we get to looking at it, and comparing it to some Remington brass that i had shot, and the Winchester brass is noticeably thinner.</p><p></p><p>So, has anyone else noticed this? Had 2 boxes, bought at 2 different stores that where noticeably thinner than the Remington brass. Maybe it was because i bought the low end Winchester ammo to start with. I have since got my hands on some Lake City brass, and the Remington brass reloaded fine with adjusting my dies.</p></blockquote><p></p>
[QUOTE="lilboots, post: 2191655, member: 24733"] Sorry if this has been discussed and i missed it. I have just started reloading, and was reloading some .308 Winchester brass I had bought and shot. Everything was fine until I went to seat the bullet. When i did, the brass buckled at the shoulder, and not just barely. So, figured I had my die set wrong, so backed it off, and tried another. Didnt even start to seat the bullet. Slowly started tightening the die back down until it seated the bullet, and buckled again. After the 4th piece of ruined brass, i gave up. Cousin, who is much more experienced at reloading, comes over, goes through the setup process again to make sure its right, and buckles the brass. So we get to looking at it, and comparing it to some Remington brass that i had shot, and the Winchester brass is noticeably thinner. So, has anyone else noticed this? Had 2 boxes, bought at 2 different stores that where noticeably thinner than the Remington brass. Maybe it was because i bought the low end Winchester ammo to start with. I have since got my hands on some Lake City brass, and the Remington brass reloaded fine with adjusting my dies. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Winchester Super X brass
Search titles only
By:
Top
Bottom