Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Wondering if members can set up loaner program for dies
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ok-22shooter" data-source="post: 3512736" data-attributes="member: 42477"><p>Buddy and I have pulled our reloading equipment out of storage and re-setting up. 4 presses and 20 or so die sets. Lucky to have a few thousand primers and lots of brass. Both shoot 9mm and 40SW in Glocks. I have not been able to purchase bulge buster type die. Need to run several thousand rounds thru a die. I have bullet molds in 357, 44, 45, 40 that I could do a loan or maybe just rent dies for a week. This shooting community knows that we are all in a bind for a while. I think it's time WE get creative and get things accomplished until hopefully things get back to normal. Send me a PM if you are interested. I can buy a carbide "bullet seating" die. I have access to a lathe and wonder the die could be bored out/cut off the top to remove the seating part of the die and make a push thru ram. Any one with a die that could measure the ID of the carbide ring?</p></blockquote><p></p>
[QUOTE="ok-22shooter, post: 3512736, member: 42477"] Buddy and I have pulled our reloading equipment out of storage and re-setting up. 4 presses and 20 or so die sets. Lucky to have a few thousand primers and lots of brass. Both shoot 9mm and 40SW in Glocks. I have not been able to purchase bulge buster type die. Need to run several thousand rounds thru a die. I have bullet molds in 357, 44, 45, 40 that I could do a loan or maybe just rent dies for a week. This shooting community knows that we are all in a bind for a while. I think it's time WE get creative and get things accomplished until hopefully things get back to normal. Send me a PM if you are interested. I can buy a carbide "bullet seating" die. I have access to a lathe and wonder the die could be bored out/cut off the top to remove the seating part of the die and make a push thru ram. Any one with a die that could measure the ID of the carbide ring? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Wondering if members can set up loaner program for dies
Search titles only
By:
Top
Bottom