Sorry if this is in the wrong location, wasn't sure exactly where something like this should go so I took my best guess!
Just wanted to give other local stamp collectors another option for getting Form1/Trust information engraved. I'm now on my third SBR project with engraving done by Jeff over at Huntington Fine Jewelers over on South Western in OKC. He's a gun guy himself and very very skilled with the super fancy engraver they have there. I'm not sure the exact details of the machine but it's apparently the only one in the State if I understood correctly and can be configured to engrave just about anything anywhere on any object. So far he's handled a typical AR lower magazine well, the unusual curved surface of an MP5 clone and is currently doing a CZ Scorpion Evo 3 for me (Forged Aluminum, Sheet Steel, and Plastic!). He's able to match font and text size of factory engraving rather closely with very precise centering wherever you decide to place your information.
I know a lot of folks may not want to pay the extra for "pretty" engraving since something cheaper would be just as effective but I wanted it to look good. I'm gonna have these for a long time so might as well go all out I figure. Turn around time so far has been about 2 weeks but it can be shorter depending on how busy he is. He also saves your engraving as a "logo" in the computer that controls the engraver so future projects are both faster and cheaper since he's already got the settings in there.
Just wanted to give other local stamp collectors another option for getting Form1/Trust information engraved. I'm now on my third SBR project with engraving done by Jeff over at Huntington Fine Jewelers over on South Western in OKC. He's a gun guy himself and very very skilled with the super fancy engraver they have there. I'm not sure the exact details of the machine but it's apparently the only one in the State if I understood correctly and can be configured to engrave just about anything anywhere on any object. So far he's handled a typical AR lower magazine well, the unusual curved surface of an MP5 clone and is currently doing a CZ Scorpion Evo 3 for me (Forged Aluminum, Sheet Steel, and Plastic!). He's able to match font and text size of factory engraving rather closely with very precise centering wherever you decide to place your information.
I know a lot of folks may not want to pay the extra for "pretty" engraving since something cheaper would be just as effective but I wanted it to look good. I'm gonna have these for a long time so might as well go all out I figure. Turn around time so far has been about 2 weeks but it can be shorter depending on how busy he is. He also saves your engraving as a "logo" in the computer that controls the engraver so future projects are both faster and cheaper since he's already got the settings in there.