Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Remington 1100 Jamming
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="mr ed" data-source="post: 1623520" data-attributes="member: 6777"><p>totally clean the gun first. this includes removing the buttstock and cleaning the action tube and spring(in the buttstock) when reassembling make sure there is no oil or grease on the magtube. </p><p>the hot gasses will fry it and it will become sticky.</p><p></p><p>if it works with the first 2 or 3 rounds then hangs on the last couple. most likely you may need a new mag spring.</p><p>the mag spring has to have a lot of power because it slams the shell into the shell lifter latch located in the trigger guard. which activates the lifter. not enough power and the action locks open like your out of shells. if it partially lifts the shell and the bolt jams the shell halfway up to the chamber. it could be the lifter spring.</p><p></p><p>at the front of the bolt carrier you should have a piece that is about 3/16" tall, flat on 1 side, beveled on the other. flat side goes against the bolt carrier. the second piece is beveled on 1 side and stepped on the other. the bevel mates with the bevel on the other piece. then put on the oring (buy a new one they are cheap) then on goes barrel,hanguard and cap.</p></blockquote><p></p>
[QUOTE="mr ed, post: 1623520, member: 6777"] totally clean the gun first. this includes removing the buttstock and cleaning the action tube and spring(in the buttstock) when reassembling make sure there is no oil or grease on the magtube. the hot gasses will fry it and it will become sticky. if it works with the first 2 or 3 rounds then hangs on the last couple. most likely you may need a new mag spring. the mag spring has to have a lot of power because it slams the shell into the shell lifter latch located in the trigger guard. which activates the lifter. not enough power and the action locks open like your out of shells. if it partially lifts the shell and the bolt jams the shell halfway up to the chamber. it could be the lifter spring. at the front of the bolt carrier you should have a piece that is about 3/16" tall, flat on 1 side, beveled on the other. flat side goes against the bolt carrier. the second piece is beveled on 1 side and stepped on the other. the bevel mates with the bevel on the other piece. then put on the oring (buy a new one they are cheap) then on goes barrel,hanguard and cap. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Remington 1100 Jamming
Search titles only
By:
Top
Bottom