Returning to reloading for handguns after ten year hiatus with rifles - and experience was minimal even then, so keep that in mind.
I picked up 500 pieces of mixed brass. Couple hundred are R-P. These are close-to or over the max lenght whereas the rest of the once-fired are well under. So l looks like I’ll need to trim the R-P at least.
I’ve used stainless pins for tumbling/cleaning for a decade and primer pockets look fine I’ve used a Wilson and have case holders for everything, including 32-20. I don’t have caseholders for the 38/.357 so had questions on trimming cases.
Question one: Anyone using a Wilson Case trimmer for 38/.357?
Question two: do you recommend the Q-style or the recessed style?
I picked up 500 pieces of mixed brass. Couple hundred are R-P. These are close-to or over the max lenght whereas the rest of the once-fired are well under. So l looks like I’ll need to trim the R-P at least.
I’ve used stainless pins for tumbling/cleaning for a decade and primer pockets look fine I’ve used a Wilson and have case holders for everything, including 32-20. I don’t have caseholders for the 38/.357 so had questions on trimming cases.
Question one: Anyone using a Wilson Case trimmer for 38/.357?
Question two: do you recommend the Q-style or the recessed style?