Assistance with last leg of AR15 build

[Hawkman]

Hey OSA! I'm putting together my first AR and the last thing that needs to happen before this rifle is fully assembled is for me to install the barrel, handguard, and gas tube. Currently I am without a workbench or vice, and am asking if someone in the Yukon/OKC area would be willing to let me use their vice and upper receiver block in order to properly install the aforementioned components. This is my first build, but I have a pretty clear picture of what goes where (not like there is much to mess up)!

I'd be happy to donate $20/case of beer/<insert your incentive here> for the trouble

 

[D. Hargrove]

Can't help ya man (I live 100 miles south of you), but good on ya for getting it built!!!! Now get those parts on order for the next one...lol

 

[Hawkman]

Can't help ya man (I live 100 miles south of you), but good on ya for getting it built!!!! Now get those parts on order for the next one...lol

XD This build has taken me ~10 months so far, and I don't even have BUIS, an optic, ammo, etc. etc. ! I think I am going to stick with one AR for a little bit

 

[dennishoddy]

I have everything to finish your rifle in Ponca city if you get up this way.

 

[tRidiot]

I have everything to finish your rifle in Ponca city if you get up this way.

Ditto that, but I'm in Bartlesville. If you or anyone else needs help, I can always make some time. I love building ARs.

 

[NikatKimber]

XD This build has taken me ~10 months so far, and I don't even have BUIS, an optic, ammo, etc. etc. ! I think I am going to stick with one AR for a little bit

I gave you a like, because I remember that sentiment! I now have four.

 

[beastep]

I just use a junk mag to support the rifle and torque it down. Its only 35ft/lbs on the low side so it dont take a whole lot. Of course the proper tools are the best way to go.

 

[okierider]

Take that $20 add a little and buy a vise at Home depot!! Not top of the line but serviceable. Every whacked out gun nut needs his very own vice!!!
http://www.homedepot.com/p/BESSEY-4-1-2-in-Light-Duty-Bench-Vise-with-Swivel-Base-BV-HW45/205023078

 

[Ignored Member]

Steve's wholesale or harbor freight has a good sized vise in the $50 range. You'll end up using it for way more things than just the AR build.

 

[gfercaks33]

If you need to use a vise and an upper block I live in Nw okc but will be in available till next week, you are more then welcome to swing by one evening and borrow them. I also have a couple large crow foot wrenches I've used for my builds unless you have the wrench you need.