Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
260 to 308?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rickt300" data-source="post: 3801855" data-attributes="member: 50678"><p>I have a put together Remington 700 in 260 Remington, not a super expensive set up but it is a tack driver. I have a few more than 500 match bullets to run through it which will coincide with being close to the end of the barrels accuracy life. I'm thinking about going to a Criterion 308 barrel. Reason being I have plenty of brass, both match and hunting bullets are usually available. The rifle as a 260 commonly makes groups in the .3 to .4 area. 3 shot groups commonly just under .3. Can I expect this kind of accuracy from a properly set up 308? It appears I may have posted this in the wrong forum but to fix it I will list my best shooting 260 load. Nosler brass, uniformed primer pockets and outside neck turned, 120 gr. Barnes Matchburner, 32.5 grains of I3031, Federal standard primer. It shoots the Hornady 140 grain BTHP almost as well using I4350. Don't use it as much because the other load just flat outshoots it every time but it is hard to complain about half inch groups.</p></blockquote><p></p>
[QUOTE="Rickt300, post: 3801855, member: 50678"] I have a put together Remington 700 in 260 Remington, not a super expensive set up but it is a tack driver. I have a few more than 500 match bullets to run through it which will coincide with being close to the end of the barrels accuracy life. I'm thinking about going to a Criterion 308 barrel. Reason being I have plenty of brass, both match and hunting bullets are usually available. The rifle as a 260 commonly makes groups in the .3 to .4 area. 3 shot groups commonly just under .3. Can I expect this kind of accuracy from a properly set up 308? It appears I may have posted this in the wrong forum but to fix it I will list my best shooting 260 load. Nosler brass, uniformed primer pockets and outside neck turned, 120 gr. Barnes Matchburner, 32.5 grains of I3031, Federal standard primer. It shoots the Hornady 140 grain BTHP almost as well using I4350. Don't use it as much because the other load just flat outshoots it every time but it is hard to complain about half inch groups. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
260 to 308?
Search titles only
By:
Top
Bottom