Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
300 blackout converted brass - any problems?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Blitzfike" data-source="post: 2451093" data-attributes="member: 807"><p>Tyrome in Tulsa also has converted 5.56 brass to 300AAC, I don't know if Ty still has any or not, but you could contact him. I convert all my own, I do use a case Gauge to verify that my shoulder is set in the right position when doing the forming. I form with a standard Lee full length sizing die and then fireform with a reduced load. I anneal <u>AFTER</u> conversion and so far I haven't had s single case fail with as many as 8 reloads. If you load high pressure loads your brass will fail a lot sooner. I shoot it out of a single shot encore, an AR and a bolt rifle. I love being able to load light load with cast bullets and shoot them out of the non AR rifles.</p></blockquote><p></p>
[QUOTE="Blitzfike, post: 2451093, member: 807"] Tyrome in Tulsa also has converted 5.56 brass to 300AAC, I don't know if Ty still has any or not, but you could contact him. I convert all my own, I do use a case Gauge to verify that my shoulder is set in the right position when doing the forming. I form with a standard Lee full length sizing die and then fireform with a reduced load. I anneal [U]AFTER[/U] conversion and so far I haven't had s single case fail with as many as 8 reloads. If you load high pressure loads your brass will fail a lot sooner. I shoot it out of a single shot encore, an AR and a bolt rifle. I love being able to load light load with cast bullets and shoot them out of the non AR rifles. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
300 blackout converted brass - any problems?
Search titles only
By:
Top
Bottom