Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
300 blackout............good, bad or indifferent??
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="lkothe" data-source="post: 2918167" data-attributes="member: 30900"><p>Finished getting parts for my .300blk today from FBT.....mounted my SS 16" FBT barrel on the Anderson upper and installed the low profile gas block/tube.....went to dimple the barrel for gas block set screw and the entire upper popped out of the vise! Grrrrr I hadn't tightened it down enough and of course the barrel hit the concrete garage floor right on the end, dinging the flash hider threads. Sighs....30 slow minutes with a small triangle file and the flash hider screwed on with no problems. 12.5" FBT forward grip mounted up and its ready to shoot with the new nitride BCG and a med Gunfighter charging handle.</p><p></p><p>Any problems with shooting it with my 5.56 lower? </p><p>Hope to load some 125's tomorrow pushed by a bit of 1680...</p></blockquote><p></p>
[QUOTE="lkothe, post: 2918167, member: 30900"] Finished getting parts for my .300blk today from FBT.....mounted my SS 16" FBT barrel on the Anderson upper and installed the low profile gas block/tube.....went to dimple the barrel for gas block set screw and the entire upper popped out of the vise! Grrrrr I hadn't tightened it down enough and of course the barrel hit the concrete garage floor right on the end, dinging the flash hider threads. Sighs....30 slow minutes with a small triangle file and the flash hider screwed on with no problems. 12.5" FBT forward grip mounted up and its ready to shoot with the new nitride BCG and a med Gunfighter charging handle. Any problems with shooting it with my 5.56 lower? Hope to load some 125's tomorrow pushed by a bit of 1680... [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
300 blackout............good, bad or indifferent??
Search titles only
By:
Top
Bottom