Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
45 acp shot shells My homemade brass
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="swampratt" data-source="post: 2408327" data-attributes="member: 15054"><p>Sorry to hear about the hospital stay..Hope everything is ok.</p><p></p><p>The Id is .400" at the powder level..I see where you are headed..Make a wad that is a nice fit.</p><p></p><p>And this :</p><p>An improvement on the rolling of the case mouth</p><p>I built an insert i drop into my 45 acp factory carbide crimp die..I remove the insert that crimps and drop this into it.</p><p>Then twist the top back on.</p><p></p><p>Makes a nicer finished product. This was a bungee nut.</p><p>I drilled a flare into it and turned down the OD so it fits snug in the die.</p><p>I then polished it to some extent with a cartridge roll and then some cratex rubberized abrasive.</p><p>[ATTACH]36107[/ATTACH]</p></blockquote><p></p>
[QUOTE="swampratt, post: 2408327, member: 15054"] Sorry to hear about the hospital stay..Hope everything is ok. The Id is .400" at the powder level..I see where you are headed..Make a wad that is a nice fit. And this : An improvement on the rolling of the case mouth I built an insert i drop into my 45 acp factory carbide crimp die..I remove the insert that crimps and drop this into it. Then twist the top back on. Makes a nicer finished product. This was a bungee nut. I drilled a flare into it and turned down the OD so it fits snug in the die. I then polished it to some extent with a cartridge roll and then some cratex rubberized abrasive. [ATTACH=CONFIG]36107[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
45 acp shot shells My homemade brass
Search titles only
By:
Top
Bottom