Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Anyone got an outside neck turner?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DRC458" data-source="post: 3170357" data-attributes="member: 530"><p>... with a .257 pilot that I could borrow? Or, maybe I could pay you to do a little outside neck turning for me? Here's the story ... loading for two different .25-284's ... one Winchester and one Savage. Have loaded with re-formed 6.5-284 brass ... some Hornady, some Nosler, and some Lapua ... and with two different sets of dies ... RCBS and Pacific. Especially with the Lapua brass, we can hardly close the bolt on some of them. All full-length re-sized and trimmed to length. I've loaded for that Savage for a while and never had this issue, but was not loading Lapua brass. I mic'd the necks of some various loaded ammo, and it seems the Lapua, in some cases, runs about .010" larger than the others. I also thought about small based dies, but would like to figure this out without a lot of additional expense. I don't just want to throw money at it! Your thoughts?</p></blockquote><p></p>
[QUOTE="DRC458, post: 3170357, member: 530"] ... with a .257 pilot that I could borrow? Or, maybe I could pay you to do a little outside neck turning for me? Here's the story ... loading for two different .25-284's ... one Winchester and one Savage. Have loaded with re-formed 6.5-284 brass ... some Hornady, some Nosler, and some Lapua ... and with two different sets of dies ... RCBS and Pacific. Especially with the Lapua brass, we can hardly close the bolt on some of them. All full-length re-sized and trimmed to length. I've loaded for that Savage for a while and never had this issue, but was not loading Lapua brass. I mic'd the necks of some various loaded ammo, and it seems the Lapua, in some cases, runs about .010" larger than the others. I also thought about small based dies, but would like to figure this out without a lot of additional expense. I don't just want to throw money at it! Your thoughts? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Anyone got an outside neck turner?
Search titles only
By:
Top
Bottom