Anyone use aa2230?

[minihawk1]

I aquired some at H&H and was wondering if this is a clean burning powder. So far I know it is a fast burn powder from the load data off their website.

 

[ASP785]

It meters very precisely out of my Hornady and is my go to powder for high volume 223 loading. I use it primarily with AR's so clean burning is sort of a relative term. I would not describe it as being a 'dirty' powder though.

 

[tbsadavid]

The cleanest burning powder that I use for my .223 loads is Hodgdon Benchmark.

 

[minihawk1]

It meters very precisely out of my Hornady and is my go to powder for high volume 223 loading. I use it primarily with AR's so clean burning is sort of a relative term. I would not describe it as being a 'dirty' powder though.

I figured it would meter well since its a ball powder. I didn't mean to make it sound like me asking if it burns with no residue just relatively ok where it won't foul up my guns.

The cleanest burning powder that I use for my .223 loads is Hodgdon Benchmark.

I am loading this powder out if my dillon 650 press so it can be mass produced for my ARs.

 

[aeropb]

Its fantastic for 223

 

[Blitzfike]

I've loaded about 32 pounds of it in 223 for my menagerie.. Shoots well. Last couple of years I've been using milsurp powders, but the 2230 is my goto in commercial for bulk 223. I can get a little better accuracy with the Varget loads in my 223 bolt, but it may just be a quirk of that rifle. Blitzfike

 

[Oklahomabassin]

It is an excellent powder for .223.

 

[AKmoose]

My go to in .556 also, excellent powder.

 

[minihawk1]

Any load data would be appreciated with this powder and 55gn or 62gn bullets. I'm using federal 205 primers if it matters. Thanks

 

[tbsadavid]

From Modern Reloading Second Edition by Richard Lee---55 gn Start load-23.4 gns @2923 fps - Max load 26.0 gns @ 3216 fps --COL 2.230. 62 gn Start load-21.3 gns @2765 fps - Max load23.7 gns @ 3043 fps. COL 2.250. Check these rounds to ensure they fit into your magazine.