Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Ar trigger polishing.
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Glocktogo" data-source="post: 2843390" data-attributes="member: 1132"><p>I'd be a hypocrite if I said I haven't done a lot of "Mil-Spec+" trigger jobs, I'm just trying to discourage the use of anything abrasive on the surfaces. If you hit them with a little Flitz or Simichrome paste on a felt Dremel bob, <u>then apply a quality grease to those surfaces</u>, it's as good as possible with stock parts SAFELY. Adding the JP "yellow" springs and doing a speed cut on the hammer makes it that much better, but use the "red" duty springs if you're going to use it for defense. Regardless, always conduct all required safety checks with an empty gun before adding live ammo!</p><p></p><p> <a href="http://guns.wonderhowto.com/how-to/perform-functions-check-your-own-ar-15-rifle-267086/" target="_blank">http://guns.wonderhowto.com/how-to/perform-functions-check-your-own-ar-15-rifle-267086/</a></p><p></p><p>The reason Geissele and other top notch triggers are so much better is because most are two stage instead of single stage and more importantly, the hammer/trigger engagement is neutral, rather than positive. That means when you pull the trigger, the hammer is released from the same position it's in at rest. With a mil-spec single stage, the trigger pulls the hammer back a few thousandths of an inch further back before releasing it. </p><p></p><p>Hope this helps!</p></blockquote><p></p>
[QUOTE="Glocktogo, post: 2843390, member: 1132"] I'd be a hypocrite if I said I haven't done a lot of "Mil-Spec+" trigger jobs, I'm just trying to discourage the use of anything abrasive on the surfaces. If you hit them with a little Flitz or Simichrome paste on a felt Dremel bob, [u]then apply a quality grease to those surfaces[/u], it's as good as possible with stock parts SAFELY. Adding the JP "yellow" springs and doing a speed cut on the hammer makes it that much better, but use the "red" duty springs if you're going to use it for defense. Regardless, always conduct all required safety checks with an empty gun before adding live ammo! [url]http://guns.wonderhowto.com/how-to/perform-functions-check-your-own-ar-15-rifle-267086/[/url] The reason Geissele and other top notch triggers are so much better is because most are two stage instead of single stage and more importantly, the hammer/trigger engagement is neutral, rather than positive. That means when you pull the trigger, the hammer is released from the same position it's in at rest. With a mil-spec single stage, the trigger pulls the hammer back a few thousandths of an inch further back before releasing it. Hope this helps! [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Ar trigger polishing.
Search titles only
By:
Top
Bottom