Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rimfire Weapons
finally scored a S&W .22 LR Revolver, model 18 K-22
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="_CY_" data-source="post: 1262610" data-attributes="member: 7629"><p>just got off the line with Brownells and Midway USA. </p><p>ordered a factory cylinder stop, hand with springs and a bunch of other parts I've been needing. </p><p></p><p>cylinder gap measured at .007in between barrel and cylinder. .008in feeler gauge barely slid in. rear cylinder gap is tight at less than .007in. </p><p></p><p>spec from S&W is under .010in for front, .014in for rear. so my cylinder is very tight. side to side rotation should be .002-.003in or barely any movement. K-22 is sloppy greater than .010in, but still shoots fairly accurate. </p><p></p><p>since I'm doing the cylinder stop. odds are it will change timing, so might as well replace the hand too. </p><p></p><p><strong>[Broken External Image]</strong></p></blockquote><p></p>
[QUOTE="_CY_, post: 1262610, member: 7629"] just got off the line with Brownells and Midway USA. ordered a factory cylinder stop, hand with springs and a bunch of other parts I've been needing. cylinder gap measured at .007in between barrel and cylinder. .008in feeler gauge barely slid in. rear cylinder gap is tight at less than .007in. spec from S&W is under .010in for front, .014in for rear. so my cylinder is very tight. side to side rotation should be .002-.003in or barely any movement. K-22 is sloppy greater than .010in, but still shoots fairly accurate. since I'm doing the cylinder stop. odds are it will change timing, so might as well replace the hand too. [b][Broken External Image][/b] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rimfire Weapons
finally scored a S&W .22 LR Revolver, model 18 K-22
Search titles only
By:
Top
Bottom