Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
GSI 300blk trim kit
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Coug91" data-source="post: 3262350" data-attributes="member: 44269"><p>I had one for my 650 and it worked well. I'd say better than the Dillon because it speechwriter air flow. I bought one when I upgraded to a 1050, but it didn't work as well as the 650 had. Just wasn't getting enough air flow. So I went back to the Dillon for my1050. I was using the Bosch 2.5HP router and Dillon carbide 300BLK trim die on an ammobot at about 2250 pounds per hour. One day I'll setup the press again.</p></blockquote><p></p>
[QUOTE="Coug91, post: 3262350, member: 44269"] I had one for my 650 and it worked well. I'd say better than the Dillon because it speechwriter air flow. I bought one when I upgraded to a 1050, but it didn't work as well as the 650 had. Just wasn't getting enough air flow. So I went back to the Dillon for my1050. I was using the Bosch 2.5HP router and Dillon carbide 300BLK trim die on an ammobot at about 2250 pounds per hour. One day I'll setup the press again. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
GSI 300blk trim kit
Search titles only
By:
Top
Bottom