Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Handcrafted Canyon Jumper
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="swampratt" data-source="post: 3539205" data-attributes="member: 15054"><p>Lapua worked well in my 2 .308 rifles.</p><p>But I could not get into the upper accuracy node as the case would not allow that much powder without severe compression.</p><p>Winchester cases for the win there.</p><p>R-P cases for my 30-06 but as with any case they get annealed each time and so much bras prep I am more concerned where my brass is than where the bullet lands ..I know where the bullet will land.. Right where I aimed.</p><p></p><p>Lapua cases in my .243 and .223 had to have the necks turned as they were way too thick for my tight chambers</p><p>and accuracy was like a shotgun pattern.</p><p>Winchester in .243 and I use Federals in my .223 and 5.56.</p><p></p><p>Is the PRVI brass the same as PPU?</p></blockquote><p></p>
[QUOTE="swampratt, post: 3539205, member: 15054"] Lapua worked well in my 2 .308 rifles. But I could not get into the upper accuracy node as the case would not allow that much powder without severe compression. Winchester cases for the win there. R-P cases for my 30-06 but as with any case they get annealed each time and so much bras prep I am more concerned where my brass is than where the bullet lands ..I know where the bullet will land.. Right where I aimed. Lapua cases in my .243 and .223 had to have the necks turned as they were way too thick for my tight chambers and accuracy was like a shotgun pattern. Winchester in .243 and I use Federals in my .223 and 5.56. Is the PRVI brass the same as PPU? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Handcrafted Canyon Jumper
Search titles only
By:
Top
Bottom