Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Firearms Chat
Hard primers in Hornady?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="adamsredlines" data-source="post: 2933420" data-attributes="member: 40561"><p>I'm back!</p><p></p><p>Tried this lower on two different uppers today with two different ammo brands and nada.</p><p>Also tried a new-to-me upper on this lower and my own which has been flawless thus far and it wouldnt run either....so I got all kinds of "problems".</p><p></p><p>Hammer spring orientation matches between my two lowers. </p><p></p><p>With the new upper on the new lower sometimes it wouldnt eject, sometimes it wouldnt reset hammer and pick up new round...so I'm guessing its short stroking which would point to something in the gas system? (Too long, wrong port size, etc?) Gas system of both uppers is same length however...so I'd think that means its bleeding it off in the new upper or has too small of a port? </p><p></p><p>I dont remember what the new lower did on my good upper but it wasnt functioning correct. </p><p></p><p>I'm obviously no AR Guru. I know enough to get the basics and operation but aside from that I'm all ears.</p></blockquote><p></p>
[QUOTE="adamsredlines, post: 2933420, member: 40561"] I'm back! Tried this lower on two different uppers today with two different ammo brands and nada. Also tried a new-to-me upper on this lower and my own which has been flawless thus far and it wouldnt run either....so I got all kinds of "problems". Hammer spring orientation matches between my two lowers. With the new upper on the new lower sometimes it wouldnt eject, sometimes it wouldnt reset hammer and pick up new round...so I'm guessing its short stroking which would point to something in the gas system? (Too long, wrong port size, etc?) Gas system of both uppers is same length however...so I'd think that means its bleeding it off in the new upper or has too small of a port? I dont remember what the new lower did on my good upper but it wasnt functioning correct. I'm obviously no AR Guru. I know enough to get the basics and operation but aside from that I'm all ears. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Firearms Chat
Hard primers in Hornady?
Search titles only
By:
Top
Bottom