Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
Headed to Moore - Chainsaw Recommendations?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="madokie" data-source="post: 2200234" data-attributes="member: 3462"><p>even a medium size saw like my husky 445 (12#) gets tiresome real quick lugging it around,you wont be constantly using it, you arm will fall off first.a small light echo or stilh with a 10" bar will cut a lot of stuff, save a larger saw for when you need it.if you think you will be dulling chain too often bring a dremil rotory tool with grinding bits , they sell bits for this in chainsaw section at lowes and home depot, you can resharpen chain in the field if you have 120V,or get a 12V to 120V converter,resharpened this way is not like a pro shop resharpened job but it will get the saw cutting again,just be VERY carefull.if you get a small saw dont get one where the chain tightening is adjusted with some plastic junk knob, get a saw where you loosen a nut or 2 , then with flat blade screwdriver tighten chain and then re tightnen nuts back down.</p></blockquote><p></p>
[QUOTE="madokie, post: 2200234, member: 3462"] even a medium size saw like my husky 445 (12#) gets tiresome real quick lugging it around,you wont be constantly using it, you arm will fall off first.a small light echo or stilh with a 10" bar will cut a lot of stuff, save a larger saw for when you need it.if you think you will be dulling chain too often bring a dremil rotory tool with grinding bits , they sell bits for this in chainsaw section at lowes and home depot, you can resharpen chain in the field if you have 120V,or get a 12V to 120V converter,resharpened this way is not like a pro shop resharpened job but it will get the saw cutting again,just be VERY carefull.if you get a small saw dont get one where the chain tightening is adjusted with some plastic junk knob, get a saw where you loosen a nut or 2 , then with flat blade screwdriver tighten chain and then re tightnen nuts back down. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
Headed to Moore - Chainsaw Recommendations?
Search titles only
By:
Top
Bottom