Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
Help with gas log fireplace
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="twoguns?" data-source="post: 2681907" data-attributes="member: 7012"><p>WARNING: Improper installation,</p><p>adjustment, alteration, service,</p><p>or maintenance can cause</p><p>injury or property damage. Refer</p><p>to this manual for correct</p><p>installation and operational</p><p>procedures. For assistance or</p><p>additional information <em>consult</em></p><p><em>a qualified installer, service</em></p><p><em>agency, or the gas supplier.</em></p><p></p><p>What is your gas pressure, What type of fuel NG, LP?</p><p></p><p>Burner does not light after ODS/pilot is lit</p><p></p><p>1. Burner orifice clogged</p><p>2. Inlet gas pressure is too low</p><p>3. Burner orifice diameter is too small</p><p>4. Thermopile leads disconnected or improperly</p><p>connected</p><p>5. Burners will not come on in remote</p><p>position</p><p> </p><p>1. Clean burner (see Cleaning and Maintenance,</p><p>page 17) or replace burner orifice</p><p>2. Contact local natural gas company</p><p>3. Replace burner orifice</p><p>4. Reconnect leads (see Wiring Diagram,</p><p>page 21)</p><p>5. Replace battery in transmitter and</p><p>receiver</p></blockquote><p></p>
[QUOTE="twoguns?, post: 2681907, member: 7012"] WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual for correct installation and operational procedures. For assistance or additional information [I]consult a qualified installer, service agency, or the gas supplier.[/I] What is your gas pressure, What type of fuel NG, LP? Burner does not light after ODS/pilot is lit 1. Burner orifice clogged 2. Inlet gas pressure is too low 3. Burner orifice diameter is too small 4. Thermopile leads disconnected or improperly connected 5. Burners will not come on in remote position 1. Clean burner (see Cleaning and Maintenance, page 17) or replace burner orifice 2. Contact local natural gas company 3. Replace burner orifice 4. Reconnect leads (see Wiring Diagram, page 21) 5. Replace battery in transmitter and receiver [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
Help with gas log fireplace
Search titles only
By:
Top
Bottom