Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
New Ruger mag project
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="steelfingers" data-source="post: 3017273" data-attributes="member: 38658"><p>Here is partial view of the bottom of the stock and mag well. I will cut and fit flat aluminum to the bottom of the stock forming the piece to fit into the space where the screw for the mag catch is now (it's the one in the picture that I made out of washers. The mag catch screw will attach the flat piece that will fit perfectly over the magwell and extend to about the trigger. It's a perfect fit as the mag well on the stock is indented to the same depth as the mag catch and stock. I will cut a hole matching the magwell I just built and fit it in, where the mag will seat perfectly into to the bolt.</p><p>When I find the perfect spot, I will braze the bottom plate to the vertical magwell.</p><p>The front end will be cut off flush and the back will be cut off leaving a small piece to use to insert a spring/mag release that I will make and cut a slit in the mag well for it to fit into.</p></blockquote><p></p>
[QUOTE="steelfingers, post: 3017273, member: 38658"] Here is partial view of the bottom of the stock and mag well. I will cut and fit flat aluminum to the bottom of the stock forming the piece to fit into the space where the screw for the mag catch is now (it's the one in the picture that I made out of washers. The mag catch screw will attach the flat piece that will fit perfectly over the magwell and extend to about the trigger. It's a perfect fit as the mag well on the stock is indented to the same depth as the mag catch and stock. I will cut a hole matching the magwell I just built and fit it in, where the mag will seat perfectly into to the bolt. When I find the perfect spot, I will braze the bottom plate to the vertical magwell. The front end will be cut off flush and the back will be cut off leaving a small piece to use to insert a spring/mag release that I will make and cut a slit in the mag well for it to fit into. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
New Ruger mag project
Search titles only
By:
Top
Bottom