Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Firearms Chat
This could get expensive
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="adamsredlines" data-source="post: 3944137" data-attributes="member: 40561"><p>So I started a new job right before Thanksgiving....back doing mechanical design, now at a fab shop. Been working on stuff for them and finally asked about personal projects and found out they charge employees wholesale for metal and basically nothing for cut/weld/bend time.</p><p></p><p>Have a few little ideas in the works, first project is some different paddles for the backyard ranges Texas Star. It has 3" paddles, and got a test piece 4" cut which fit great so tomorrow I'll "order" a full set of 4" and 5" ones. Orange below is the original 3", raw is 4". Can swap them out based on shooter/experience level.</p><p></p><p>[ATTACH=full]337949[/ATTACH]</p><p></p><p>[ATTACH=full]337950[/ATTACH]</p><p></p><p></p><p>I had some down time today so modeled up a target like the MGM spinner. I'll request a "quote" on it tomorrow but I suspect it should be a mere fraction of the cost of ordering one from MGM.</p><p></p><p>[ATTACH=full]337952[/ATTACH]</p></blockquote><p></p>
[QUOTE="adamsredlines, post: 3944137, member: 40561"] So I started a new job right before Thanksgiving....back doing mechanical design, now at a fab shop. Been working on stuff for them and finally asked about personal projects and found out they charge employees wholesale for metal and basically nothing for cut/weld/bend time. Have a few little ideas in the works, first project is some different paddles for the backyard ranges Texas Star. It has 3" paddles, and got a test piece 4" cut which fit great so tomorrow I'll "order" a full set of 4" and 5" ones. Orange below is the original 3", raw is 4". Can swap them out based on shooter/experience level. [ATTACH type="full"]337949[/ATTACH] [ATTACH type="full"]337950[/ATTACH] I had some down time today so modeled up a target like the MGM spinner. I'll request a "quote" on it tomorrow but I suspect it should be a mere fraction of the cost of ordering one from MGM. [ATTACH type="full"]337952[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Firearms Chat
This could get expensive
Search titles only
By:
Top
Bottom