Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Will it fit
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="NikatKimber" data-source="post: 3128949" data-attributes="member: 423"><p>It might be close. There are two places you would need to check:</p><p></p><p>1 - at the eyepiece (rear of the scope). Measure outside of scope body there, divide by two, then compare that to the height listed for the rings. OD/2 must be less than ring height.</p><p></p><p>2 - at the objective (front of scope). Measure outside of body (not 50mm - that's the inside lens diameter), divide by two. Measure distance between top of rail on upper, and top of round handguard, and add that to the ring height. Compare values. OD/2 must be less than ring height + upper/HG difference.</p><p></p><p>If both both are less, then it will FIT. If it will be the appropriate height for you is another question.</p></blockquote><p></p>
[QUOTE="NikatKimber, post: 3128949, member: 423"] It might be close. There are two places you would need to check: 1 - at the eyepiece (rear of the scope). Measure outside of scope body there, divide by two, then compare that to the height listed for the rings. OD/2 must be less than ring height. 2 - at the objective (front of scope). Measure outside of body (not 50mm - that's the inside lens diameter), divide by two. Measure distance between top of rail on upper, and top of round handguard, and add that to the ring height. Compare values. OD/2 must be less than ring height + upper/HG difference. If both both are less, then it will FIT. If it will be the appropriate height for you is another question. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Will it fit
Search titles only
By:
Top
Bottom