I'm needing to confirm the torque on my muzzle break before I finish everything up. Anybody have one on south side OKC or Moore I can borrow?
Do you have a torque wrench to attach to it? I'm assuming yes... but personally, I've never used one. There's a pretty wide range of torque specs, so I don't worry too much about it. Although I think I just found my torque wrench a few weeks ago, so now I should be able to be more scientific about it. 
Yes, I have a torque wrench. Specs on my break say to torque to 20ft pounds if I recall. I put it on with a crescent wrench just to get it mounted, but want to make sure since there will be bullets flying through that part.
Yup, the crush washer is on. It crushed some, but wasn't sure if that was enough to meet the specs in the documentation that came with the brake.
Okay. Thanks everybody.
If I were nearby, I'd have no problem coming over to lend a hand. Or have you bring your rifle over and we'd check the torque on the barrel, too. I'm a bit far, though. Sorry.
I installed the barrel some time ago. It's all good to go. I torqued down everything else and it's ready to hit the range. Thanks all for the advise and offers.
