I recently installed a Daewoo Puma 10HC 2 axis lathe in the Tromix shop and need some help getting the tooling set up for it.
Is there anyone here familiar with the tooling holders/fixtures for the turret that would be interested in moonlighting a bit? I have plenty of beer.
Contact via e-mail below would be best.
Tony Rumore
Tromix Corp
E-mail [email protected]
Edited - This should have been the General Discussion forum. Sorry about that.
Is there anyone here familiar with the tooling holders/fixtures for the turret that would be interested in moonlighting a bit? I have plenty of beer.
Contact via e-mail below would be best.
Tony Rumore
Tromix Corp
E-mail [email protected]
Edited - This should have been the General Discussion forum. Sorry about that.
