7mm Mauser (7x57) brass - Found the dies!

[Dumpstick]

All the bullets I have pulled were with a simple inertia puller.
No marks on the bullet at all.
No way to pull a soft lead bullet and reuse it with a collet puller.

I don't want to pull and reuse a soft lead bullet. I want to pull and reuse a factory jacketed bullet.

I want to pull it with a collet puller because it is easier to reuse the powder that way. The case is upright in the press, I just grab it out of the holder and dump the powder into the scale pan to weigh and modify.

An inertia puller makes a mess, and it impossible to ascertain the original powder charge, because I have never managed to save all the powder - it goes flying everywhere.

I have a Lyman 7mm 135gn 2 cavity mold that I may part with -- my problem is I also have a custom 280Rem/7mm rifle w/ about 45rds ammo that I am thinking about selling. If I sell it the buyer may want the mold. I should know within a couple weeks if I want to sell it

Let me know if you want to sell it.