Where are you guys getting load data or are you just playing with different loads?
Whatcha loading for? I been cross referencing and it looks like AA#2 data is pretty close. I only recently started using it and I only plan on using WST for lead bullet loads.
It takes some searching but over on the enos forum you can find numbers if you dig enough.
Brian-Enos? Been there a few times, but havent really drilled into the forums too deep.
Mainly, lead/alloy cast bullets in .40s&w (light loads cause of glock), 9mm and 45ACP.
When you say AA#2 is pretty close, is that across the board? Pressure, velocity, etc?
Thanks for responding.
I using 4.4 grains under a J&K 124RN in 9mm. It shoots great and cycles my M&P Pro and my kids Sig P6 flawlessly. Fairly soft load and a lot less smoke and soot than others.
Where are you guys getting load data?
All Hodgdon manufactured powder loading data are on line, including for Winchester WST:
http://data.hodgdon.com/main_menu.asp
Enter your email address to join: