- Joined
- Dec 17, 2007
- Messages
- 6,100
- Reaction score
- 1,562
Over all I'm a big fan of the LNL AP. 95%+ of the problems I've had were operator induced and the more I use it the fewer hangups I have.
I'm going to be calling Hornady tomorrow and I'll let you know how that goes.
However I am having a problem with the bushings that are in the press, the female side of the system. I've had several pieces of bushing shear off the lands and fall out At first I didn't know what the heck they were but after I had collected several of them I figured it out. The bottom part of the land is breaking off. Now in station one there is only one left and on a tough case it lets the resizing die torque up a little which is bad. The station where I have my powder measure is also doing this and it lets the die bushing shift sometimes
Does anyone know if the female part of the bushing (the part that is solid in the press) is user replaceable or is Hornady gonna want this thing in house?
I'm going to be calling Hornady tomorrow and I'll let you know how that goes.
However I am having a problem with the bushings that are in the press, the female side of the system. I've had several pieces of bushing shear off the lands and fall out At first I didn't know what the heck they were but after I had collected several of them I figured it out. The bottom part of the land is breaking off. Now in station one there is only one left and on a tough case it lets the resizing die torque up a little which is bad. The station where I have my powder measure is also doing this and it lets the die bushing shift sometimes
Does anyone know if the female part of the bushing (the part that is solid in the press) is user replaceable or is Hornady gonna want this thing in house?