Man there is just something about a big knife!! Here is the 2nd generation of the "Oklahoma Pig Sticker" The "Oklahoma Boar skewer" This one is built on 0-1 tool steel @ 1/4" stock thickness. The Blade profile allows for a very fine sharp tip even at 1/4" stock thickness. I gave it a slight belly from back to tip in case some chopping or wood work is in order. I put some holes in it for front and rear lanyard options. The blade has a differential heat treatment if you look close you can see the Hamon line just below the primary bevel line a slight etching would bring it out but this one needs a dull mirror finish. There is a nice place mid way down the spine for a little batoning if that is in order. Its heavy......
13.5" total length, blade came in at 8 1/4" with 8" of cutting edge @ 1/4" stock thickness, handle and guard makes up the rest. Handle is black canvas micarta with brass guard and pins.
13.5" total length, blade came in at 8 1/4" with 8" of cutting edge @ 1/4" stock thickness, handle and guard makes up the rest. Handle is black canvas micarta with brass guard and pins.