Last time I shot 300 rounds of that steel cased Winchester ammo and had a bunch of extraction problems, the kind where the spent casing doesn't get extracted out of the chamber and a new round bumps into it when trying to get chambered. Happened more than I wanted.
This time I took it out with 400 rounds of brass Federal fmjs and Remington jhps/fmj ammo and was a whole lot better. However, it still had 3 or 4 extraction problems (way less than last time). The first time I didn't really focus on accuracy since I just wanted to see if it was broken, but happy to report that accuracy was very nice this time around.
What do you think I should do about the extraction problem? Figure I could watch some videos to learn how to remove and give it a cleaning, though I'm not sure if that'll ruin the warranty. I'll have to check. I could send it back to Sig if it's needed, but that'll suck.
This time I took it out with 400 rounds of brass Federal fmjs and Remington jhps/fmj ammo and was a whole lot better. However, it still had 3 or 4 extraction problems (way less than last time). The first time I didn't really focus on accuracy since I just wanted to see if it was broken, but happy to report that accuracy was very nice this time around.
What do you think I should do about the extraction problem? Figure I could watch some videos to learn how to remove and give it a cleaning, though I'm not sure if that'll ruin the warranty. I'll have to check. I could send it back to Sig if it's needed, but that'll suck.