Stock repair

cdexter87

Marksman
Special Hen
Joined
Oct 10, 2018
Messages
18
Reaction score
4
Location
US
I have an Winchester 94 xtr big bore. I needing someone who could fix a crack on tang. I tryed looking for a new stock but only ones I find are angle eject or unchecked. Any suggestions on a smith that could do the repair. Located Tahlequah
b3d992d56702884d9593c13148ca6879.jpg


Sent from my SM-G960U using Tapatalk
 
Last edited:

Catt57

Gill-Gun Guru
Special Hen Supporter
Joined
Aug 1, 2014
Messages
4,338
Reaction score
6,518
Location
OKC
I have an Winchester 94 xtr big bore. I needing someone who could fix a crack on tang. I tryed looking for a new stock but only ones I find are angle eject or unchecked. Any suggestions on a smith that could do the repair. Located Tahlequah
b3d992d56702884d9593c13148ca6879.jpg


Sent from my SM-G960U using Tapatalk

It's hard to tell the extent of the damage. Is it just on the surface or does it go further in?



While I appreciate the mention, I'm not sure I want to get into doing this for hire. It's one thing to do your own gun, but when doing it for someone else and you mess up, that's a whole world of liabilities I don't want to deal with. Not to mention the labor involved is usually worth more than what most people are willing to pay.
 

cdexter87

Marksman
Special Hen
Joined
Oct 10, 2018
Messages
18
Reaction score
4
Location
US
It's hard to tell the extent of the damage. Is it just on the surface or does it go further in?




While I appreciate the mention, I'm not sure I want to get into doing this for hire. It's one thing to do your own gun, but when doing it for someone else and you mess up, that's a whole world of liabilities I don't want to deal with. Not to mention the labor involved is usually worth more than what most people are willing to pay.
Just the surface as far as I can tell I took it off and didn't see a crack inside where tang inlets into stock

Sent from my SM-G960U using Tapatalk
 

BReeves

Sharpshooter
Special Hen Supporter
Joined
Feb 18, 2010
Messages
2,627
Reaction score
1,330
Location
Catoosa
Think I would just squirt (wick) some thin CA (superglue) into the crack and be done with it. If I was ambitious I might cover it with some plastic wrap (won't stick to the glue) and try to press the piece back down flush. Might need a little cleaning up but should work.
 
Top Bottom