Had another problem with the Sig 365 extracting a round today. Different manufacturer (Federal) but same grain (115).
It's not picking up the spent round and causing a near double feed and it's the same problem I had last time I sent it back to sig. Had put well over a thousand rounds through since it's return. but this is getting to be too much. Going to take a close look at it tonight before I decide to send back or request my money back.
On the other hand, the CZ P07 ran great.
Pic 1 is the sig with the spent casing in barrel. Pic two is my P07 doing well at 12 yds. Pic three is P07 at 20 yds. Pic 3 is the sig at 12 yds before the fail.
It's not picking up the spent round and causing a near double feed and it's the same problem I had last time I sent it back to sig. Had put well over a thousand rounds through since it's return. but this is getting to be too much. Going to take a close look at it tonight before I decide to send back or request my money back.
On the other hand, the CZ P07 ran great.
Pic 1 is the sig with the spent casing in barrel. Pic two is my P07 doing well at 12 yds. Pic three is P07 at 20 yds. Pic 3 is the sig at 12 yds before the fail.