And I'm pretty disappointed so far. I tried to install it - put it on the bolt-stop and started to screw it together (making sure it was lined up right and flush together).
I was using my thumb and forefinger only and using the short side of the Torx-bit L-wrench that came with it and it barely got firm (screw-head was flush with the screw-hole) and then it was loose again. I thought to myself "surely it didn't just strip", so I kept turning the wrench and sure enough - it wasn't getting any tighter no matter how long I turned it.
I backed it out and looked and sure enough, the threads are pulled out and around the screw.
I've got tons of Magpul products, so I'm assuming this is just a bad one, but no more pressure than I was putting on it when tightening down on the screw, there's no way it should have stripped (talking inch/Lbs).
I was using my thumb and forefinger only and using the short side of the Torx-bit L-wrench that came with it and it barely got firm (screw-head was flush with the screw-hole) and then it was loose again. I thought to myself "surely it didn't just strip", so I kept turning the wrench and sure enough - it wasn't getting any tighter no matter how long I turned it.
I backed it out and looked and sure enough, the threads are pulled out and around the screw.
I've got tons of Magpul products, so I'm assuming this is just a bad one, but no more pressure than I was putting on it when tightening down on the screw, there's no way it should have stripped (talking inch/Lbs).