Too much powder :(

[lkothe]

Its been a while since I loaded some of my 9mm so last night I ran a 100 rounds thru the Lee single stage.
This evening I looked at my ammo box label again. ... 4.1 gr of Unique behind 147 gr Berrys plated.
Hmmm something ain't right my mind says......recheck my powder measure....it's throwing what I set it at.
4.7 gr! !
I was wearing my seldom worn work bi focal safety glasses and had mistaken 4.1 for 4.7.

Jeez I feel foolish.

I'm on the way to pulling the 147's........ I'm thinking empty powder, pull primers, bell the case mouth, reprime and reload with correct grains this time.
Any other suggestions?

DNO

 

[dennishoddy]

Why pull the primers?
Remove the decapper from the sizing die, and run them though. No problem.

 

[Barn Dog]

I dont see any need to pull primers, Ive done the exact same mistake.
I would just pull bullets, add powder, bullet, seat and crimp

you can pull the decapping pin out of the sizing die and resize if you need to

 

[turkeyrun]

Popping the primers is unnecessary.

 

[ssgrock3]

I would shoot them.

 

[jrusling]

I would just put the 9mm cylinder in my Blackhawk and shoot them.

 

[NikatKimber]

I would shoot them.

Alliant lists a max of 4.3gr under 9mm. I wouldn't shoot them unless you had a non-standard 9mm, like the Blackhawk jrusling has.

 

[lkothe]

My thought also....

Alliant lists a max of 4.3gr under 9mm. I wouldn't shoot them unless you had a non-standard 9mm, like the Blackhawk jrusling has.

 

[Fyrtwuck]

Check several manuals and see what the max load is.

 

[turkeyrun]

Listing for +P? What gun? Maybe just shoot them?