Has this ever happened to any of you?
Today while decapping 270 brass I got a case stuck. While on the up swing it felt a little harder than usual so i gave it a little harder pull than normal and snap, my Lee press broke in two. Bottom plate was still attached to the table and I had all the rest in my hand. Needless to say the 270 brass was decapped but now stuck in the die. After a few choice words, I tried to get the stuck case out and completly made a mess out of that. So now, They are on their way to LEE since they are still pretty new, and I hope to get them replaced. Monday started off pretty bad for me. I hope the rest of the week goes better.
Today while decapping 270 brass I got a case stuck. While on the up swing it felt a little harder than usual so i gave it a little harder pull than normal and snap, my Lee press broke in two. Bottom plate was still attached to the table and I had all the rest in my hand. Needless to say the 270 brass was decapped but now stuck in the die. After a few choice words, I tried to get the stuck case out and completly made a mess out of that. So now, They are on their way to LEE since they are still pretty new, and I hope to get them replaced. Monday started off pretty bad for me. I hope the rest of the week goes better.